Poseidon 4001: Cabinet Access Control System & Environment Monitor

Poseidon 4001 is rack Access Control System and SNMP environment monitoring for 19" cabinets. It's solution for datacenter cabinets IP-based ACS integrated with remote rack monitoring.

Poseidon 4001 is a two-in-one solution for monitoring probes (temperature, doors, voltage, power) and access control (swing handle, RFID reader). Supports an open and fully documented M2M interface (SNMP, XML).

Typical application

• Data centers
• Security systems
• HWg ACS (Access Control System)

LINKS

• Poseidon 4001: Cabinet Access Control System & Environment Monitor
  
• Flyer
• Access Control Systems presentation
• Poseidon 4001: Solution de contrôle d’accès et de surveillance des baies 19’’

HWg-WLD Relay: Water leak detector

HWg-WLD Relay detects a water leak anywhere along the length of the connected sensing cable (2+2m – 6.5+6.5ft). Water leak or cable disconnection is indicated by activating a relay (NO/NC). The sensor can be connected to a Poseidon unit over the 1-Wire UNI bus (RJ11).

HWg-WLD Relay can be installed stand-alone using a 12VDC power supply and a relay output, or as a sensor connected to a Poseidon unit over the 1-Wire UNI bus. Relay outputs indicate a detected water leak or cable disconnection.
HWg-WLD Relay is supplied with a 2m (6.5ft) sensing cable.

Typical application

LINKS

• HWg-WLD Relay: Water leak detector
• Flyer
• Press release
• HWg-WLD Relay: Vand lækage detektor
• HWg-WLD Relé: Detector de fuga de agua
• HWg-WLD Relay: detector de vazamento de água
• HWg-WLD Relay: detector zalania wodą
• HWg-WLD Relay: Détecteur de fuites d'eau
• Russian version

HWg special solution: SH2 swinghandle access system

Online cabinet Security Door Control (SDC) with Web & SNMP interface. HWg-SH2 can control front & rear doors of one cabinet. Swinghandle lock access system is controller over IP using documented M2M protocols. With the original HW group software, doors can be opened even with text messages (SMS).

HWg-SH2 is an IP-based remote cabinet door access control system. Front and rear doors of one cabinet (rack) can be connected to one HWg-SH2 unit.
The HWg-SH2 is IP lock control for various electronic locks. It is typically used with HWg-SH1 (H3-EM Electronic Locking SwingHandle by Southco) for cabinet door control.

Typical application

The HWg-SH2 is typically used to control access to a rack in a data center. It is usually installed in hosting racks (collocation centers) or restricted-access racks. HWg-SH2 is a cost-effective solution that is easy to install.

LINKS

• HWg-SH2: IP-based cabinet access system for two swinghandles
• Flyer
• Presentation
• HWg-SH2: Système d’Accès IP pour deux poignées